Bitcraze Forums

Hi,
When I try to run the "Testing the Himax camera", it will always stop at certain point like below:



Therefore, I try to find the program stop at which scentence,and find:



But 3 of my teammates can run this example successfully, and we have the same virtual envirnment.
So, I want to know is this problem may be caused by computer configuration? or there are other causes?
By the way, my teammates and I all used the offical docker. And we refer to this page:https://www.bitcraze.io/documentation/r ... st-camera/
Regards,
Mathilda

Hi Mathilda,

Curious... Are you using the same JTAG debugger, too?
We have seen similar unexpected behavior of the GAP8. I have found that it can help to first connect the JTAG debugger, before powering on the board. Give that a try and let me know if it works!

Hi gemenerik,

Thanks to your solution，it works!!!!!!!!!!
I met this problem nearly two weeks, thank you very much!
Sending you a heart!!!!!

Regards,
Mathilda