Page 1 of 1
Configure Device Mapping - Save greyed out
Posted: Thu May 09, 2013 12:33 pm
by skube
I'm trying to setup a new profile under the Configure Input Device option, but I can't save any new profile because the Save button is always greyed out. I'm using a Xbox 360 on Win 7. Is there something I'm doing wrong?
Re: Configure Device Mapping - Save greyed out
Posted: Thu May 09, 2013 12:59 pm
by jweather
You have to select an axis or button for all of the inputs, including trim +/-, killswitch, and exit app before it will let you save the config currently.
Re: Configure Device Mapping - Save greyed out
Posted: Thu May 09, 2013 1:41 pm
by skube
Ah. Thanks jweather! That's not very obvious.
Also, with the Xbox controller, you run out of buttons to map to, since the digtal pad doesn't work right now. I guess this will be fixed at a later date.
Re: Configure Device Mapping - Save greyed out
Posted: Thu May 09, 2013 2:00 pm
by marcus
Hi,
skube wrote:Also, with the Xbox controller, you run out of buttons to map to, since the digtal pad doesn't work right now. I guess this will be fixed at a later date.
Yeah, we have a few issues for this. Hopefully all of them will be fixed in the next version.
Only digital buttons supported for trim
Should not require trim/estop/exit to save config
/Marcus