[SOLVED] Crazyflie 2.0 flashes red, IMU: LPS25H Fail

[chromebookbob]

Code: Select all

SYS: ----------------------------
SYS: Crazyflie is up and running!
SYS: Build 0:1ab92e55c44b (2014.12.0) CLEAN
003B and I have 1024KB of flash!
IMU: MPU9250 I2C connection [OK].
IMU: AK8963 I2C connection [OK].
I2CDEV: Error callback nr: 1024
IMU: LPS25H I2C connection [FAIL].
EXPBRD: Found 0 memories.
EEPROM: I2C connection [OK].
AK8963: Self test [OK].
OW: Found 0.
30 78 42 43 0 50 0 0 0 0 0 0 0 0 0 7D 
Status 0
30 78 42 43 0 50 0 0 0 0 0 0 0 0 0 7D 
Status 0

I just turned on my crazyflie today, it self-tested and connected to my pc, but there is a red flashing light on it and it won't fly. Any help would be appreciated. I have tried tapping it as per the troubleshooting guide, I don't really understand what is going on.

[tobias]

Something happened with the pressure sensor chip, probably soldering that has gone bad. You can contact Seeedstudio support to get it fixed. I have also attached a firmware that disables the pressure sensor functionality so it will work again without it (altitude hold will not work).

[chromebookbob]

Thanks so much, I have contacted seeedstudio.com, but the firmware is just what I need in the meantime. I can keep working without the pressure sensor. Thanks again

[qubitter]

I have the same issue. Will the new board cost me anything?

[tobias]

No it wont as it is a manufacturing error, I sent you a PM.