Flowdeck is not working properly
Posted: Mon May 23, 2022 12:47 pm
Flowdeck measures altitudate data incorrectly. While the drone is standing on a stable ground, when we look over the cfclient, the drone appears to be standing at 1136 meters. Also it is not reading flowdeck software. Although we formatted Flowdeck but we cannot install the driver.
Code: Select all
SYS: Crazyflie 2.1 is up and running!
SYS: Build 0:8c606d1f8f89 (2022.05) CLEAN
SYS: I am 0x203936564E4B50190025004C and I have 1024KB of flash!
CFGBLK: v1, verification [OK]
DECK_INFO: Warning! No driver found for deck.
DECK_CORE: 1 deck(s) found
IMU: BMI088: Using I2C interface.
IMU: BMI088 Gyro connection [OK].
IMU: BMI088 Accel connection [OK]
IMU: BMP388 I2C connection [OK]
ESTIMATOR: Using Complementary (1) estimator
CONTROLLER: Using PID (1) controller
MTR-DRV: Using brushed motor driver
SYS: About to run tests in system.c.
SYS: NRF51 version: 2022.0
EEPROM: I2C connection [OK].
STORAGE: Storage check [OK].
IMU: BMI088 gyro self-test [OK]
SYS: Self test passed!
STAB: Wait for sensor calibration...
SYS: Free heap: 20552 bytes
STAB: Ready to fly.