thank you your answer kimberly
i use 3.8.1 SDK docker container and successfully solved the problem
But again i ran into trouble. TT
in Working directory: AIdeck_examples/GAP8/image_processing_examples/FaceDetection
i did make clean and make all PMSIS_OS=pulpos
i used make run code. and got the following error
gapy --target=ai_deck --platform=board --work-dir=/root/aideck-gap8-examples/examples/image_processing/FaceDetection/BUILD/GAP8_V2/GCC_RISCV run --exec-prepare --exec --binary=/root/aideck-gap8-examples/examples/image_processing/FaceDetection/BUILD/GAP8_V2/GCC_RISCV/face_detection
Launching execution with command:
gap8-openocd -c 'gdb_port disabled; telnet_port disabled; tcl_port disabled' -f interface/ftdi/olimex-arm-usb-ocd-h.cfg -f target/gap8revb.tcl -f tcl/jtag_boot_entry.tcl -c 'gap8_jtag_load_binary_and_start "/root/aideck-gap8-examples/examples/image_processing/FaceDetection/BUILD/GAP8_V2/GCC_RISCV/face_detection" elf 0x1c000080'
Open On-Chip Debugger 0.10.0+dev-dirty (2022-05-24-08:01)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
DEPRECATED! use 'adapter speed' not 'adapter_khz'
DEPRECATED! use 'adapter driver' not 'interface'
Warn : Interface already configured, ignoring
TARGET create
Info : core 0 selected
0
Info : gap8_adv_debug_itf tap selected
Info : adv_dbg_unit debug unit selected
Info : Option 7 is passed to adv_dbg_unit debug unit
GAP8 INIT TARGET
Error: no device found
Error: unable to open ftdi device with vid 15ba, pid 002b, description 'Olimex OpenOCD JTAG ARM-USB-OCD-H', serial '*' at bus location '*'
Traceback (most recent call last):
File "/gap_sdk/tools/gapy/gapy", line 162, in <module>
main()
File "/gap_sdk/tools/gapy/gapy", line 152, in main
operationFunc(args, config)
File "/gap_sdk/tools/gapy/run.py", line 146, in operationFunc
raise RuntimeError('Runner has failed with value: %d' % status)
RuntimeError: Runner has failed with value: -1
/gap_sdk/tools/rules/pulp_rules.mk:244: recipe for target 'run' failed
make: *** [run] Error 1
i used Olimex ARM-USB-TINY-H and 10to20 pin for debugging
How can i solve this problem?