Crazyflie Bolt parts are damaged when trying to fly a DIY drone.
Posted: Wed Apr 20, 2022 2:49 am
Hello.
I am making my own drone using Crazyflie Bolt. After turning on the power, I checked the propeller to the point where it spins, but after spinning it for a while, its parts break with a buzzer (it also emitted smoke). If you are familiar with this problem, please advise me the cause and countermeasures. (I think the cause is overcurrent.)
The relevant part is as shown in the attached image. Environment
Software used: Crazyflie 2.0 App(iPhone)
Battery: 2S, 1300mAh
Motor: F1103 KV8000 (T-motor)
ESC: AT 12A 3S (T-motor)
I am making my own drone using Crazyflie Bolt. After turning on the power, I checked the propeller to the point where it spins, but after spinning it for a while, its parts break with a buzzer (it also emitted smoke). If you are familiar with this problem, please advise me the cause and countermeasures. (I think the cause is overcurrent.)
The relevant part is as shown in the attached image. Environment
Software used: Crazyflie 2.0 App(iPhone)
Battery: 2S, 1300mAh
Motor: F1103 KV8000 (T-motor)
ESC: AT 12A 3S (T-motor)