LPS node problem
Posted: Tue May 11, 2021 12:42 am
Hi,
I updated the LPS node to the latest firmware and the LPS worked properly in TDoA2 mode. And now I am trying to access to the node low level configuration to force the TX power but facing some issues.
1. I tried to open the node low level configuration via VM. However, it showed permission denied. Then, I tried the command sudo chmod a+rw /dev/ttyACM0 to get into the configuration. Is it correct? Or am I doing something wrong? After I got into the node low level configuration, it showed these message in the terminal without any action. 2. Sometimes the terminal kept running these message after the command $ picocom /dev/ttyACM3
and I was not able to stop this and press anything. 3. This is not relevant to the node low level configuration. I was trying to change the node ID by LPS configuration tool. However, the apply button is unavailable. I am able to update the firmware but not change the configure.
Could you please advice me with these issues.
Thank you.
Best,
Yu-Hsiang
I updated the LPS node to the latest firmware and the LPS worked properly in TDoA2 mode. And now I am trying to access to the node low level configuration to force the TX power but facing some issues.
1. I tried to open the node low level configuration via VM. However, it showed permission denied. Then, I tried the command sudo chmod a+rw /dev/ttyACM0 to get into the configuration. Is it correct? Or am I doing something wrong? After I got into the node low level configuration, it showed these message in the terminal without any action. 2. Sometimes the terminal kept running these message after the command $ picocom /dev/ttyACM3
and I was not able to stop this and press anything. 3. This is not relevant to the node low level configuration. I was trying to change the node ID by LPS configuration tool. However, the apply button is unavailable. I am able to update the firmware but not change the configure.
Could you please advice me with these issues.
Thank you.
Best,
Yu-Hsiang