recent firmware upgrade (2 march 2020)
Posted: Sun Mar 15, 2020 7:09 pm
Hi all,
wanted to share that, after last week firmware upgrade (date was 2 march 2020, procedure performed via CF App on my iPad), I noticed the following:
- after rump-up, motor nr. 2 will occasionally shutdown (as an example when you try to take-off at a progressive motor rate..)
- after crashing, the CF will have to be shitched off and back on to be again controllable (though it shows as normally connected to the iPad).
That was the first firmware update since purchase.
None of the above mentioned problems where noticed with previuos version of firmware.
Tried to re-flash... now firmware is 2020.02.
Same problems still persist... it is like there is an acceleration problem setting a barrier to a new take-off after a hard landing. didnt notice that with previous (original) firmware.
Grateful if anyone could point me in a correct direction...
Thanks
A
wanted to share that, after last week firmware upgrade (date was 2 march 2020, procedure performed via CF App on my iPad), I noticed the following:
- after rump-up, motor nr. 2 will occasionally shutdown (as an example when you try to take-off at a progressive motor rate..)
- after crashing, the CF will have to be shitched off and back on to be again controllable (though it shows as normally connected to the iPad).
That was the first firmware update since purchase.
None of the above mentioned problems where noticed with previuos version of firmware.
Tried to re-flash... now firmware is 2020.02.
Same problems still persist... it is like there is an acceleration problem setting a barrier to a new take-off after a hard landing. didnt notice that with previous (original) firmware.
Grateful if anyone could point me in a correct direction...
Thanks
A