debug configuration
Posted: Sat Jun 30, 2018 11:04 am
Hello,
I recently ran into a problem while debugging crazyflie with stlink. I followed the procedure: “To start debugging go into the "Run -> Debug configurations..." dialog and under "GDB OpenOCD Debugging" I find "Crazyflie 2.0". Press the debug button”.
It should start the debug and hit a breakpoint at main, but it didn't. The eclipse interface is shown below Fig. 1 and Fig. 2. I don't know what the problem is. But I've done it before, and it stops at the break point of the main function.
I recently ran into a problem while debugging crazyflie with stlink. I followed the procedure: “To start debugging go into the "Run -> Debug configurations..." dialog and under "GDB OpenOCD Debugging" I find "Crazyflie 2.0". Press the debug button”.
It should start the debug and hit a breakpoint at main, but it didn't. The eclipse interface is shown below Fig. 1 and Fig. 2. I don't know what the problem is. But I've done it before, and it stops at the break point of the main function.