Can't apply a ID to the anchors
Posted: Fri May 10, 2019 12:07 pm
Situation:
I have 8 anchors.
They are all have the libusb-win32 (v1.2.6.0) driver from the Zadig tool.
After that the lps-node-firmware-2018.10.dfu is correctly updated with the LPS configuration tool.
But after that I can't find a way to give them a appropriate ID.
(I using the tutorial from https://www.bitcraze.io/getting-started ... ng-system/)
I have 8 anchors.
They are all have the libusb-win32 (v1.2.6.0) driver from the Zadig tool.
After that the lps-node-firmware-2018.10.dfu is correctly updated with the LPS configuration tool.
But after that I can't find a way to give them a appropriate ID.
(I using the tutorial from https://www.bitcraze.io/getting-started ... ng-system/)