Page 1 of 1

Loco positioning deck pinout

Posted: Fri Dec 21, 2018 4:21 am
by branilson
Hello,

I have some Loco positioning deck boards, SKU 114990655, that I'd like to use with another microcontroller rather than Crazyflie. So, I need to know the pinout of this board. Where can I find documentation of this deck?

I see that the pin headers have the same spacing than Xbee boards. May I use an Xbee adapter to address this board thru serial?

Thanks in advance.

Re: Loco positioning deck pinout

Posted: Fri Dec 21, 2018 11:30 am
by tobias
I think the difficulty is to port the FW as nothing runs on the Loco deck, else the schematics can be found here. Yes it is the same spacing as Xbee but not the full pin-out is the same.

Re: Loco positioning deck pinout

Posted: Sun Dec 23, 2018 2:47 pm
by branilson
tobias wrote:
Fri Dec 21, 2018 11:30 am
I think the difficulty is to port the FW as nothing runs on the Loco deck, else the schematics can be found here. Yes it is the same spacing as Xbee but not the full pin-out is the same.
This helps a lot.

Thank you very much, Tobias.