CF as anchor
Posted: Wed Nov 21, 2018 9:45 pm
I recently read in your blog a short description of the roadrunner device and is described as a CF2.1 and it acts as an anchor.
Can i use a CF2.0 as an anchor in a LPS using TDOA3 .
I like to evaluate how the use of more anchors improves the precision of the location especially in z axis, currently i have 8 anchors, one in each corner of a cube 4 x 4 mts.
We like to test before of make any purchase.
We also test the Flowdeck V1.0 with the flow disabled, only using it as Z ranger with good results, but the distance range is limited to 1,5 mts aprox and can't be used in combination with the led ring. (we broke a LED ring trying to use the hole trick) and this applies to V2.0
We suggest that in future versions of the LED ring take that into consideration, it is better a ring that a disc and is also better below than above.
We have been testing the new outiler filter in the last firmware, but it seems to perform better in TDOA3 than in TDOA2. can it be possible?
Can i use a CF2.0 as an anchor in a LPS using TDOA3 .
I like to evaluate how the use of more anchors improves the precision of the location especially in z axis, currently i have 8 anchors, one in each corner of a cube 4 x 4 mts.
We like to test before of make any purchase.
We also test the Flowdeck V1.0 with the flow disabled, only using it as Z ranger with good results, but the distance range is limited to 1,5 mts aprox and can't be used in combination with the led ring. (we broke a LED ring trying to use the hole trick) and this applies to V2.0
We suggest that in future versions of the LED ring take that into consideration, it is better a ring that a disc and is also better below than above.
We have been testing the new outiler filter in the last firmware, but it seems to perform better in TDOA3 than in TDOA2. can it be possible?