Change ID without USB
Posted: Thu Jun 07, 2018 9:53 am
Hi All,
I would like to know if it is possible to change the ID of a beacon using the FTDI pins on the board, Unfortunately, we have broken the usb connector.
I tried connecting to it via picocom on linux but cant see any data in or out. Are there any special settings or commands which needs to be sent to enable it.
Thanks,
Khris
I would like to know if it is possible to change the ID of a beacon using the FTDI pins on the board, Unfortunately, we have broken the usb connector.
I tried connecting to it via picocom on linux but cant see any data in or out. Are there any special settings or commands which needs to be sent to enable it.
Thanks,
Khris