Bitcraze Forums

Hi, I want to put the battery on the expansion board on the bottom of CF2.0 I don't like battery's wires and connector so the battery will supply the board through the expansion board legs. Is this possible? connector_multiplexing.png I suppose ground goes to GND (left 10 pin), but what about "...

Oh, great! Thanks, chad.

chad wrote:I'd rather a $1USD mount break than the PCB airframe's arm though!

Indeed, you're right

Hello, I use CF 2.0 with Crazyradio PA with gamepad controll. Very often CF turns off when I try to increase thrust from a ground. It happens time to time, most of all when I increase thrust deeply (I control it in a normal flight mode). Then I need to manually turn it on and the bug may or may not ...

One more thing - the motor holder is not sturdy enough - I've broke two of them already

It finally came to Russia and I managed it to flie! Thank you wery much for this dev kit copter. It's awesome! My two cents feedback: I would like the battery could be attached to the board as the expansion board does. Fixed position with no wires at all would be great. I don't like the wires go thr...

So the only way to control it remotely is Crazyradio (PA) or some transmitters that are based on Nordic Semiconductor's chips. Am I right?

Let's say I have Turnigy 9x with module and receiver (Turnigy 9X8C-V2 8-channel receiver).
How can I connect the receiver to crazyflie? Is this possible?

I found this in wiki: http://wiki.bitcraze.se/projects:crazyflie:hacks:et6i The ESKY ET6I Remote Control is compatible to the Crazyflie as they share the same radio chipset Where can I find compatible transmitters? Sorry if this is nub question, but I couldn't find any info in bitcraze wiki about tr...

Hi, I'd like to buy radio transmitter to control crazyflie 2.0,
say the model Flysky FS-T6 2.4GHz 6-CH.
Is this possible? Do I need to install reciever on crazyflie or the transmitter can be linked directly to nRF51822 radio chip?