Bitcraze Forums

Hi,
I encountered some problems when deploying DroNet. When I used under /pulp-dronet-v2/gapflow/ to deploy the DroNet, I encountered this problem:https://pastebin.pl/view/9e1a8baf
I asked pulp-dronet on GitHub, but I didn't get a reply, so I can only ask here.
Is there anyone has solutions?
gap_sdk=3.8 python=3.7( I tried gap_sdk=3.9 but met more Errors )

Regards,
Mathilda

hi!

As you see here above, we are moving to https://discussions.bitcraze.io/, so could you please post this question there under Q&A? Internally at Bitcraze we haven't tried this one out yet but perhaps somebody from the community? Anyway, there is a bigger chance that somebody will see it at discussions.

kimberly wrote: ↑Fri May 27, 2022 3:13 pm hi!

As you see here above, we are moving to https://discussions.bitcraze.io/, so could you please post this question there under Q&A? Internally at Bitcraze we haven't tried this one out yet but perhaps somebody from the community? Anyway, there is a bigger chance that somebody will see it at discussions.

I'll try on it. Thank you for you reply