Repair broken battery connector on board

Firmware/software/electronics/mechanics
Post Reply
tungnx94
Beginner
Posts: 11
Joined: Wed Dec 27, 2017 11:49 am

Repair broken battery connector on board

Post by tungnx94 » Thu Jun 07, 2018 10:40 am

Hello,

after a crash my battery connector is cut at soldering point. The drone therefore cannot receive power. Image I'm very inexperienced in electronics stuff, so I would be very glad for some detailed instructions as what to do, what tools do I need.

Thanks all.

cflie2
Beginner
Posts: 12
Joined: Tue Feb 13, 2018 8:45 pm

Re: Repair broken battery connector on board

Post by cflie2 » Thu Jun 07, 2018 5:43 pm

Yes, it is too weak!!

I also have that experience...
I hope they resolve this issue for the next version of crazyflie.

In my case, I just soldered.. but it was very hard for me.
Because the working space of cf2 is narrow and the wire hole is very tiny, it is hard to solder.
Moreover, solder does not melt easily sometime.

Good luck!

Post Reply