Change ID without USB

All discussions related to the Loco Positioning system
Post Reply
kross787
Beginner
Posts: 9
Joined: Thu Jan 18, 2018 3:12 pm

Change ID without USB

Post by kross787 » Thu Jun 07, 2018 9:53 am

Hi All,

I would like to know if it is possible to change the ID of a beacon using the FTDI pins on the board, Unfortunately, we have broken the usb connector.

I tried connecting to it via picocom on linux but cant see any data in or out. Are there any special settings or commands which needs to be sent to enable it.

Thanks,

Khris

arnaud
Bitcraze
Posts: 1650
Joined: Tue Feb 06, 2007 12:36 pm

Re: Change ID without USB

Post by arnaud » Mon Jun 11, 2018 11:01 am

Hi,

It should be possible but it requires to recompile the firmware. If you enable the USE_FTDI_UART flag the node will use the FTDI serial port instead of the USB uart: https://github.com/bitcraze/lps-node-fi ... akefile#L6

Post Reply