LPS node cannot be updated
Posted: Tue May 29, 2018 9:53 am
hello!
I'm now facing a problem about the LPS anchor.That is, when connected to my computer(windows 10),with usb driver correctly installed and the LPS configuration tool running, it turns out that the node can only be configured and the update button is disabled,just like this picture showes, So I only have the node configured and it showes it's successfully applied.However,when I run the pc cfclient,though the cfclient is connected to the cf,and the LPS anchor is on,the anchors are all red ,shown as below According to the tutorial of LPS,I figure out it's someting wrong with the configuration. But many times of configuration following the instruction of tutorial all end up in vain.And now I suspect whether it is something to do with the update step. Does anyone meet this problem before?I 'll thank you for your instructing!
I'm now facing a problem about the LPS anchor.That is, when connected to my computer(windows 10),with usb driver correctly installed and the LPS configuration tool running, it turns out that the node can only be configured and the update button is disabled,just like this picture showes, So I only have the node configured and it showes it's successfully applied.However,when I run the pc cfclient,though the cfclient is connected to the cf,and the LPS anchor is on,the anchors are all red ,shown as below According to the tutorial of LPS,I figure out it's someting wrong with the configuration. But many times of configuration following the instruction of tutorial all end up in vain.And now I suspect whether it is something to do with the update step. Does anyone meet this problem before?I 'll thank you for your instructing!