I'm pretty much an electronics n00b. Please forgive my n00bness. Does this sound like the result of a shoddy soldering job? How can I debug this problem?
The software that I've used:
https://github.com/RGassmann/nRF24LU1P_SPI_Flashing
https://github.com/zerog2k/nrfprog
Example session with my Crazyradio PA hooked up to a Bus Pirate:
Code: Select all
$ ./nrfprog /dev/ttyUSB7 output
Opening the Bus Pirate UART
Setting the Bus Pirate to Binary Mode
Configuring SPI mode
Backing up the info page
starting read operation
Reading from the device to output
starting read operation
Putting the Bus Pirate back in normal operating mode
Closing the Bus Pirate
$ ls -og
total 80
-rw-r--r-- 1 1396 feb 26 21:52 README.md
-rw-r--r-- 1 15331 feb 26 21:52 nrfprog.c
-rw-r--r-- 1 418 feb 26 21:52 nrf24le1.h
-rw-r--r-- 1 1731 feb 26 21:52 bp.h
-rw-r--r-- 1 194 apr 10 13:46 Makefile
-rwxr-xr-x 1 24888 apr 10 13:46 nrfprog
-rw-r--r-- 1 512 apr 10 16:18 info_page.dat
-rw-r--r-- 1 16384 apr 10 16:18 output
$ cat output
$ hd output
00000000 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 |................|
*
00004000