Page 1 of 1
Getting Started with development on CF 2.0
Posted: Wed Jan 21, 2015 5:01 pm
by nrg0004
I just purchased the CF 2.0 and can fly it off using the PC client and iOS. However, I would like to do some development and add additional sensors. I went through the wiki page and different posts and found numerous threads that explain differently. Some advice to use the VM and then they also talk about flashing firmware and then about debugging. Is there any guide/document/process which I can follow first to understand the development process. I am looking for a step-by-step procedure to understand operation.
Thank you.
Re: Getting Started with development on CF 2.0
Posted: Tue Feb 10, 2015 1:44 pm
by Call_me_a_Cab
Wiki Guide under construction, Should be up by the weekend.
I will post a link when it's done.
Re: Getting Started with development on CF 2.0
Posted: Mon Feb 16, 2015 8:24 pm
by Call_me_a_Cab
Re: Getting Started with development on CF 2.0
Posted: Tue Feb 17, 2015 12:44 am
by Greensprings
anything comptable with windows xp?
Re: Getting Started with development on CF 2.0
Posted: Tue Feb 17, 2015 5:01 pm
by Call_me_a_Cab
I'm sure it's very similar for importing the VM. Once that's done, It will all be relevant.
Re: Getting Started with development on CF 2.0
Posted: Tue Feb 17, 2015 6:10 pm
by Greensprings
anyone know what version is compatable with xp, i looked at the documentation, but it wouldnt say
i tried installing 6.5 and 6.4 and it was a no go
Re: Getting Started with development on CF 2.0
Posted: Tue Feb 17, 2015 11:34 pm
by poizone
Greensprings wrote:anyone know what version is compatable with xp, i looked at the documentation, but it wouldnt say
i tried installing 6.5 and 6.4 and it was a no go
Do not expect XP to be supported. XP is end of life, and should not be used on an internet facing computer due to the myriad of open security flaws that will never be patched.
Re: Getting Started with development on CF 2.0
Posted: Fri Feb 27, 2015 9:07 pm
by nrg0004