Bitcraze Forums

It's hard to see what's going on in the picture. There's too much flux splattered around. You might be able to clean it off with isopropyl (rubbing) alcohol and a small brush... Then you'll be better able to see if there are any disconnect or bridged parts still.

Also a magnifier and third-hand are essential!

I have buy a new soldering iron with a little tip and the 3rf hand 2x not enough for a big operation.
I have warmed around the ground connector and it's OK

Thanks again !

My soldering station is a Hakko FX888D that I really like. I also got this curved micro tip for it that works really well!