[SOLVED] LED-Ring not detected in Client software

[kahuna001]

I just bought the LED-Ring and I know I plugged in properly. In the Client software, the detected board is greyed out. Am I missing something here ? I even flashed my 2.0 with the latest firmware. I am running the client on OS X.

It would be nice to be able to run the "RealFlight" Futaba controller with the Client software. It is detected on the OS X.

Thanks.

[tobias]

If you look at the console output tab in the cfclient after a boot does it output something like "EXPBRD: Found 1 board"?

[kahuna001]

It was a bad board. I got another one and it has been working fine until I updated the python client software. Now I don't even have the tab to select the LEDs anymore. This is the console output. It found the board.
SYS: Crazyflie is up and running!
SYS: Build 0:1ab92e55c44b (2014.12.0) CLEAN
SYS: I am 0x37333632313347032A0026 and I have 1024KB of flash!
IMU: MPU9250 I2C connection [OK].
IMU: AK8963 I2C connection [OK].
IMU: LPS25H I2C connection [OK].
EXPBRD: Found 1 memories.
EXPBRD: Info board 0:
-Header:EB
-Pins :0x8000
-Vid :BC
-Pid :1
-crc :23
EEPROM: I2C connection [OK].
AK8963: Self test [OK].
LPS25H: Self test [OK].
OW: Found 1.
OW: Serial 0xD 3E CB 8 0 0 0 88.
SYS: Free heap: 5872 bytes

[kahuna001]

SOLVED..
Must be the codes I download and merged. I deleted everything and downloaded fresh and now I have all the tabs including ALT1 and ALT2.