[SOLVED] Can crazyradio be flashed by other programmer ?

Post here to get support
Post Reply
baicker
Beginner
Posts: 20
Joined: Tue Dec 31, 2013 5:24 am

[SOLVED] Can crazyradio be flashed by other programmer ?

Post by baicker »

I havn't bought the bus pirate yet, Can crazyradio be flashed by other programmer like avr ?
I saw the P2 is a 10PIN interface, but it havn't contain the CSN pin, should i flash it without connecting the CSN pin ?

sorry for my pool english :?
Last edited by baicker on Thu Jan 16, 2014 10:04 am, edited 1 time in total.
tobias
Bitcraze
Posts: 2339
Joined: Mon Jan 28, 2013 7:17 pm
Location: Sweden

Re: Can crazyradio be flashed by other programmer ?

Post by tobias »

It could be programmed with AVR I think but a "driver" would have to be written to do it. The nRF24LU1+ chip can be programmed over SPI so with a tool that can do that it is possible but not for any beginner. Also the voltage levels have to be compatible. If I recall correctly the nRF24LU1+ is only 3.3V tolerant.
baicker
Beginner
Posts: 20
Joined: Tue Dec 31, 2013 5:24 am

Re: Can crazyradio be flashed by other programmer ?

Post by baicker »

tobias wrote:It could be programmed with AVR I think but a "driver" would have to be written to do it. The nRF24LU1+ chip can be programmed over SPI so with a tool that can do that it is possible but not for any beginner. Also the voltage levels have to be compatible. If I recall correctly the nRF24LU1+ is only 3.3V tolerant.
thanks tobias.
Post Reply