I'm trying to test if I have the motors wired in the correct order, and when I use the CFClient to issue a propeller test, I get the following error:
Code: Select all
STAB: Ready to fly.
STAB: Acc noise floor variance X+Y:0.003686, (Z:0.002372)
STAB: Motor M1 variance X+Y:0.003287 (Z:0.001701)
STAB: Motor M2 variance X+Y:0.003989 (Z:0.002357)
STAB: Motor M3 variance X+Y:0.003518 (Z:0.002738)
STAB: Motor M4 variance X+Y:0.003716 (Z:0.002365)
Code: Select all
SYS: Crazyflie Bolt is up and running!
SYS: Production release 2019.09
SYS: I am 0x20373347344D500E0032003D and I have 1024KB of flash!
CFGBLK: v1, verification [OK]
DECK_CORE: 2 deck(s) found
DECK_CORE: Calling INIT on driver bcMultiranger for deck 0
DECK_CORE: Calling INIT on driver bcZRanger for deck 1
IMU: BMI088 Gyro SPI connection [OK].
IMU: BMI088 Accel SPI connection [OK]
IMU: BMP388 I2C connection [OK]
ESTIMATOR: Using Complementary (1) estimator
CONTROLLER: Using PID (1) controller
MTR-DRV: Using brushless motor driver
EEPROM: I2C connection [OK].
MR: Init front sensor [OK]
MR: Init back sensor [OK]
MR: Init up sensor [OK]
MR: Init left sensor [OK]
MR: Init right sensor [OK]
DECK_CORE: Deck 0 test [OK].
DECK_CORE: Deck 1 test [OK].
STAB: Wait for sensor calibration...
SYS: Free heap: 9624 bytes
Any ideas?