fail to flash using radio

Discussions and questions about the Crazyflie Nano Quadcopter
Post Reply
zhoujincheng
Beginner
Posts: 8
Joined: Wed Sep 26, 2018 3:18 am

fail to flash using radio

Post by zhoujincheng »

I bought a new CF2,and I flash crazyflie-firmware using radio,i'm sure the source code is right.

after flashing , CF2 still cannot fly and the two blue LEDs (2 and 3)are fully fit.when I connect to radio with crazyflie client. the four LEDs are all fully fit(1,2,3,4). why this problem happen?
arnaud
Bitcraze
Posts: 2538
Joined: Tue Feb 06, 2007 12:36 pm

Re: fail to flash using radio

Post by arnaud »

It may happen that flashing fails, in that case you should just try again. If you cannot start the Crazyflie in bootloader mode (this can happen if flashing the nRF51 failed), you can always enter the bootloader by disconnecting the battery, pressing the button and connecting the battery while the button is pushed and finally releasing the button when the blue LED flashes.

If it still does not work I suggest you try flashing a release firmware to make sure the Crazyflie is working.
Post Reply