Hello,
after a crash my battery connector is cut at soldering point. The drone therefore cannot receive power. I'm very inexperienced in electronics stuff, so I would be very glad for some detailed instructions as what to do, what tools do I need.
Thanks all.
Repair broken battery connector on board
Re: Repair broken battery connector on board
Yes, it is too weak!!
I also have that experience...
I hope they resolve this issue for the next version of crazyflie.
In my case, I just soldered.. but it was very hard for me.
Because the working space of cf2 is narrow and the wire hole is very tiny, it is hard to solder.
Moreover, solder does not melt easily sometime.
Good luck!
I also have that experience...
I hope they resolve this issue for the next version of crazyflie.
In my case, I just soldered.. but it was very hard for me.
Because the working space of cf2 is narrow and the wire hole is very tiny, it is hard to solder.
Moreover, solder does not melt easily sometime.
Good luck!