Hi
I want to start developing with Loco-position node I having experience in c and RTOS.
I am using keil as I'm used to it. I seen your programming is in eclipse ide so how should i start programming (run lps-node-firmware) eclipse ide.
Thanks.
starting with loco position node
Re: starting with loco position node
Hi,
I am one of the main developper of the node and I am not using Eclipse so we do not have a default eclipse configuration yet. I am mainly building the project using "make" in a console (and using Atom as editor).
If you want to configure eclipse for this project you can look at the wiki, there is some instruction available: https://wiki.bitcraze.io/doc:crazyflie: ... #ide_setup
You might also be able to edit the project directly in keil and configure it to build by launching make instead of using the keil compiler. A quick google search shows that keil can use GCC so it might be possible to make it use the Makefile as well.
I hope this helps you going forward
I am one of the main developper of the node and I am not using Eclipse so we do not have a default eclipse configuration yet. I am mainly building the project using "make" in a console (and using Atom as editor).
If you want to configure eclipse for this project you can look at the wiki, there is some instruction available: https://wiki.bitcraze.io/doc:crazyflie: ... #ide_setup
You might also be able to edit the project directly in keil and configure it to build by launching make instead of using the keil compiler. A quick google search shows that keil can use GCC so it might be possible to make it use the Makefile as well.
I hope this helps you going forward