Hi there,
This is my first post and well, rather than a question, I wanted to share my Chasis design for the CF2.
A link here can give you all that I made and some basic instructions.
http://www.thingiverse.com/thing:2066146.
I purposely put an angle in the POD arm to remove stress from the Mainboard in the event of a collision.
I also separated the legs from the PODS to also protect and to absorb landing stress.
I have also made a Power Protector that you just squeeze on and off saving your little CF2 from switch damage
32 Grams with CF2
Enjoy and thank you
Brebs
Crazyflie 2 Printable Chasis
Re: Crazyflie 2 Printable Chasis
Hi Breds,
Thanks for sharing!
Does the fact that you have longer arms to the motors affect the flight performances? I would think that the attitude PID control loop would need different tunning parameter if the motor position is changed.
Anyway it looks really good, we will try to print it to test.
/Arnaud
Thanks for sharing!
Does the fact that you have longer arms to the motors affect the flight performances? I would think that the attitude PID control loop would need different tunning parameter if the motor position is changed.
Anyway it looks really good, we will try to print it to test.
/Arnaud
Re: Crazyflie 2 Printable Chasis
Hey there,
Well, so far my test have been small and ok. However, you may indeed be correct. If so I can adjust it as initially in my design, the legs were still using the PODs for the support, and the angle took the pressure away from the POD arm. So now making it straight (if required) is easy and maybe needed.
good luck and I hope it goes ok for you.
Well, so far my test have been small and ok. However, you may indeed be correct. If so I can adjust it as initially in my design, the legs were still using the PODs for the support, and the angle took the pressure away from the POD arm. So now making it straight (if required) is easy and maybe needed.
good luck and I hope it goes ok for you.