Synched to the latest master branch and ran it. My LPS25H is reporting a temperature problem:
SYS: I am 0x3132383231334715360022 and I have 1024KB of flash!
CFGBLK: v1, verification [OK]
MPU9250 I2C connection [OK].
AK8963 I2C connection [OK].
LPS25H I2C connection [OK].
DECK_DRIVERS: Found 7 drivers
DECK_INFO: Found 0 deck memory.
DECK_CORE: 0 deck enumerated
EEPROM: I2C connection [OK].
AK8963: Self test [OK].
LPS25H: Self test temperature [FAIL]. low: -20.0, high: 80.0, measured: 101.49
Are the low/high values for the test accurate? I wonder if the LPS25H is reporting deg F instead of deg C?
LPS25H failing temperature test
-
theseankelly
- Expert
- Posts: 153
- Joined: Mon Dec 28, 2015 3:23 pm
- Contact:
LPS25H failing temperature test
http://www.thejumperwire.com
Tips, tutorials, and science about DIY electronics, drones, and embedded software.
Tips, tutorials, and science about DIY electronics, drones, and embedded software.
Re: LPS25H failing temperature test
Well, I had second thoughts on the commit enabling the LPS25H moving avg filter. There was a comment saying the temperature reading became wrong when enabling it but I tested it with no problem. My guess is that I had a newer chip with this error fixed... Can you try and disable the the filter by commenting out the 4 lines from here?
Re: LPS25H failing temperature test
Found the problem and just pushed a fix.