No USB Devices Attached?

Post here to get support
Post Reply
BizziRick
Beginner
Posts: 3
Joined: Sun Dec 27, 2015 7:32 pm

No USB Devices Attached?

Post by BizziRick »

Hello,

I have installed Virtual Box and Virtual Machine (VM). Host and guest are both Windows. The problem I have is that my VM does not see my USB devices that are attached? I have a Xbox controller and CrazyRadio PA dongle which my host computer sees but my VM does not?

Whenever I try to get my VM to see the USB devices, I get a "busy" error. Is there anything I can try to do to fix this?

Thanks.
Attachments
bitcrazebusyerror.jpg
chad
Expert
Posts: 555
Joined: Sun Sep 28, 2014 12:54 am
Location: New York, USA
Contact:

Re: No USB Devices Attached?

Post by chad »

Hi BizziRick, welcome to the forum!

I don't run Windows or even VirtualBox for that matter but usually a problem like this happens when the host (Windows) isn't releasing a USB device so the guest (Linux VM) can take it over. See if these solutions work for you:

https://forums.virtualbox.org/viewtopic ... 4&start=15
https://forums.virtualbox.org/viewtopic.php?f=6&t=29034
Crazyflier - my CF journal...
4x Crazyflie Nano (1.0) 10-DOF + NeoPixel Ring mod.
3x Crazyflie 2.0 + Qi Charger and LED Decks.
Raspberry Pi Ground Control.
Mac OS X Dev Environment.
Walkera Devo7e, ESky ET6I, PS3 and iOS Controllers.
BizziRick
Beginner
Posts: 3
Joined: Sun Dec 27, 2015 7:32 pm

Re: No USB Devices Attached?

Post by BizziRick »

Thanks but I had no luck with those articles/posts.

Is Virtual Box/VM required to run the CrazyFlie client? Can I run CrazyFlie client directly on my Windows 7 host computer? I'd be more than happy to try that out.

I'm just trying to follow the instructions to get the right software downloaded so I can start learning how to program this CrazyFlie. I can fly CrazyFlie with the iOS app but it is hard to control and so I'm looking forward to more "fine tune" flying control.

Thanks.
chad
Expert
Posts: 555
Joined: Sun Sep 28, 2014 12:54 am
Location: New York, USA
Contact:

Re: No USB Devices Attached?

Post by chad »

BizziRick wrote:Can I run CrazyFlie client directly on my Windows 7 host computer? I'd be more than happy to try that out.
You sure can! Have a look at the instructions here on Github.
Crazyflier - my CF journal...
4x Crazyflie Nano (1.0) 10-DOF + NeoPixel Ring mod.
3x Crazyflie 2.0 + Qi Charger and LED Decks.
Raspberry Pi Ground Control.
Mac OS X Dev Environment.
Walkera Devo7e, ESky ET6I, PS3 and iOS Controllers.
Post Reply