Help with 6 Axis Controller

Firmware/software/electronics/mechanics
Post Reply
huhlig
Beginner
Posts: 1
Joined: Sat Mar 01, 2014 9:28 pm

Help with 6 Axis Controller

Post by huhlig »

I recently acquired a Volantex RC Usb Controller. Can anyone give me some insight as to how to hook it up to CF client properly. Axis 0, 1 and 5 act pretty much normally(pitch, yaw and roll respectively) however (Axis2) Thrust wants to start in the middle and I cant figure out how to properly make 0 throttle start at -32767 and 100% throttle be at 32767. Axis 3 and 4 are toggle buttons but jstest reports them also as analog axis. Being eigther -32767 in the near position or positive 32767 being in the far position. Is there any way I can map this properly in cfclient? http://i.imgur.com/GHX1UGc.jpg
Post Reply