Moldable Plastic for Repairs - Polymorph!

Firmware/software/electronics/mechanics
Post Reply
myrcfocus
Beginner
Posts: 9
Joined: Mon Sep 23, 2013 4:15 pm

Moldable Plastic for Repairs - Polymorph!

Post by myrcfocus » Tue Sep 24, 2013 11:25 am

This may come in handy for any small repairs on your CrazyFlie

It's a low melting point thermoplastic, that can be reused over and over.

You put it in boiling water, then mold it into any shape you want... let it cool and walla, plastic in any shape you want.

This could be used instead of a 3d printer for a camera mount for example - all be it - far less precise and a little more messy ;) But cheaper lol

Check the video below...
http://www.youtube.com/watch?v=IhVuc6RNyaw



Post Reply