Source Code Location?

Firmware/software/electronics/mechanics
Post Reply
marhar
Beginner
Posts: 1
Joined: Fri Feb 01, 2013 7:20 pm

Source Code Location?

Post by marhar » Fri Feb 01, 2013 7:21 pm

I saw in one of the announcements that this will be an open-source project.

Any pointers to where the source code will be, and estimated release date?



arnaud
Bitcraze
Posts: 2028
Joined: Tue Feb 06, 2007 12:36 pm

Re: Source Code Location?

Post by arnaud » Fri Feb 01, 2013 10:33 pm

Hi,
The source code is at https://bitbucket.org/bitcraze

It is still missing some pieces but everything should be uploaded during the weekend

ataraxic
Beginner
Posts: 4
Joined: Thu Feb 07, 2013 9:54 am
Location: Switzerland
Contact:

Re: Source Code Location?

Post by ataraxic » Thu Feb 07, 2013 11:49 am

are you planning to have git repository?
scio me nihil scire

umrashrf
Beginner
Posts: 3
Joined: Wed Feb 06, 2013 12:24 pm

Re: Source Code Location?

Post by umrashrf » Fri Feb 08, 2013 9:33 am

"This is git hosted on Bitbucket."

My bad didn't know Mercurial was there as well.
Last edited by umrashrf on Mon Apr 14, 2014 6:56 pm, edited 1 time in total.

arnaud
Bitcraze
Posts: 2028
Joined: Tue Feb 06, 2007 12:36 pm

Re: Source Code Location?

Post by arnaud » Fri Feb 08, 2013 5:45 pm

This is actually mercurial repos. We are not planing on switching to Git as mercurial suits our needs. The mercurial work-flow is very similar to git.

If you really cannot get used to mercurial it is still possible to work with git while pushing/pulling to mercurial: http://stackoverflow.com/questions/8834 ... repository

mikevoyt
Beginner
Posts: 9
Joined: Thu Feb 07, 2013 4:43 pm

Re: Source Code Location?

Post by mikevoyt » Thu Feb 28, 2013 11:01 pm

Hi,

Have you disabled pull requests? I fixed something with the Crazyflie PC client (to use 'type'-'id' as the key for inputMap dictionary, so that we can map a button and an axis with the same id), and attempted a pull request, but get "Access denied".

thanks,
-mike

marcus
Bitcraze
Posts: 599
Joined: Mon Jan 28, 2013 7:02 pm
Location: Sweden
Contact:

Re: Source Code Location?

Post by marcus » Fri Mar 01, 2013 7:33 am

Hi Mike,

Great! No, we haven't changed the settings for the pull-request since we got the last pull-request for the pc client.

/Marcus

Arjumand
Beginner
Posts: 1
Joined: Wed Dec 31, 2014 5:08 am

Re: Source Code Location?

Post by Arjumand » Wed Dec 31, 2014 5:17 am

Great, I think we have our first community development started. I'm not the python and PC expert so I hope Arnaud or Marcus will jump in. I know Arnaud quickly tested the cfclient on OSX but had problems with the joystick driver. Other then that I think it worked pretty easily.

Implementing what you want should not be any problem as long as you can translate the commands into roll, pitch, yaw and thrust.
Arjumand

Post Reply