Hi!
I'm newly interested in drones and I'm trying to make my own board referring to Crazyflie 2.0. And I did it.
I made my board using opened source and schematics. but I don't know what to do next.
Using st-link, the most recent firmware and VM(also S110, nrf52_sdk), I did 'make factory_reset' for erasing and flashing the firmware.
I guess i have to flash stm32-bootloader and stm32-firmware next. Am i correct?
I'm looking forward to your kind help!
Thank you!
How to flash s/w on bare-board
Re: How to flash s/w on bare-board
'make factory reset' Should setup the nRF51 to a usable state.
For the STM32 you need to flash at least the crazyflie2-stm-bootloader project in order to get the bootloader up and running, then you can bootload the Crazyflie from the crazyflie client or flash the crazyflie-firmware using SWD.
For the STM32 you need to flash at least the crazyflie2-stm-bootloader project in order to get the bootloader up and running, then you can bootload the Crazyflie from the crazyflie client or flash the crazyflie-firmware using SWD.