Could not connect to bootloader
Posted: Thu Jan 24, 2019 12:22 pm
Good Morning!
To upgrade the Crazyflie 2.0 firmware: Press the ON/OFF switch more than 1.5 second until the blue led blinks. Then release the button and the two blue leds should blink.
I have four Crazyflies 2.0. In three, the procedure was successful, however, in one of them there was an error. Only the M2 led blink, while the M3 stays on but not blinking.
The program reports: Could not connect to bootloader
How to proceed in this case?
Thanks
To upgrade the Crazyflie 2.0 firmware: Press the ON/OFF switch more than 1.5 second until the blue led blinks. Then release the button and the two blue leds should blink.
I have four Crazyflies 2.0. In three, the procedure was successful, however, in one of them there was an error. Only the M2 led blink, while the M3 stays on but not blinking.
The program reports: Could not connect to bootloader
How to proceed in this case?
Thanks