When I plug in the flow deck, the log is shown as below.
SYS: ----------------------------
SYS: Crazyflie 2.0 is up and running!
SYS: Build 12:967ab7d04d63 (2019.02 +12) MODIFIED
SYS: I am 0x203535523748500700500038 and I have 1024KB of flash!
CFGBLK: v1, verification [OK]
DECK_CORE: 0 deck(s) found
MPU9250 I2C connection [OK].
AK8963 I2C connection [OK].
LPS25H I2C connection [OK].
ESTIMATOR: Using Complementary (1) estimator
CONTROLLER: Using PID (1) controller
EEPROM: I2C connection [OK].
AK8963: Self test [OK].
SYS: Free heap: 16056 bytes
However. when I connect the multi range sensor in the same location using the same pin, it shows 1 deck(s) found.
We guess the flow deck is not connected properly. Is there a way we can check and debug the cause?
Thanks!
How to know if flow deck is connected successfully?
Re: How to know if flow deck is connected successfully?
Have you double checked that you mounted it the right way?
Possibly the deck connector could have been damaged. We had a few boards in the beginning with damaged connector which is fixable with a needle, see this post. I don't think you have one of those (you had to order them on the release day) but the connector could still be damaged, not so common but it happens.
Possibly the deck connector could have been damaged. We had a few boards in the beginning with damaged connector which is fixable with a needle, see this post. I don't think you have one of those (you had to order them on the release day) but the connector could still be damaged, not so common but it happens.