Hello, my problem is:
I could not access crazyflie's bootloader mode, so I reinstalled the firmware using a ST LINK, now when I turn it on by pressing the ON / OFF button, only the M2 blue LED turns on.
Other problems:
Now I can not connect the crazyflie via Bluetooth
I use Linux, and VM
Crazyflie don't work
Re: Crazyflie don't work
Can you still get to the bootloader by the following method?:
1. Disconnect CF (battery/USB)
2. Press the button and *at the same time* connect the CF to power (battery or USB); Keep the button pressed for 3 seconds.
3. After 3 seconds, if successful, the two blue LEDs should blink.
Note that 2. can be a two-person-job.
1. Disconnect CF (battery/USB)
2. Press the button and *at the same time* connect the CF to power (battery or USB); Keep the button pressed for 3 seconds.
3. After 3 seconds, if successful, the two blue LEDs should blink.
Note that 2. can be a two-person-job.
Re: Crazyflie don't work
I think you use stlink maybe only flash nrf.bin. I remember you also need bootloader.bin and other bin, but i forget......
-
- Beginner
- Posts: 2
- Joined: Thu Jun 14, 2018 12:51 pm
Re: Crazyflie don't work
Thank you all
I solved the problem doing the bootlooader DFU mode
I did
I solved the problem doing the bootlooader DFU mode
I did
Code: Select all
sudo dfu-util -d 0483:df11 -a 0 -s 0x08004000 -D cflie.bin