Unable to Configure Anchor Positions

All discussions related to the Loco Positioning system
Post Reply
wing
Beginner
Posts: 1
Joined: Thu Oct 24, 2019 10:15 pm

Unable to Configure Anchor Positions

Post by wing » Thu Oct 24, 2019 10:23 pm

I am currently using 6 anchors to fly one crazyflie drone. However, I am unable to configure the anchor positions. When I click "Write to anchors" there is no change.

The Anchors are being recognized on the Crazyflie client. I have the latest firmware flashed on both the crazyflie and the anchors. Initially, I was able to configure the position on two of the anchors, but when I tried to configure it again, it would not change.

Any assistance would be greatly appreciated. Thanks!



Post Reply