[SOLVED] Can't configure lps nodes after updating
Posted: Wed Jun 19, 2019 7:37 pm
Hello,
I am trying to configure 8 LPS nodes with the LPS configuration following the "getting started with the loco positioning system" however, when connecting the node via usb to my computer, nothing happens and the "apply" button is grayed out. I've installed Zadig and installed libusb-win32 (v1.2.6.0) to all of them, and I have updated each node with lps-node-firmware-2018.10.dfu
Once the the update it complete, the node switches from DFU mode to its regular mode automatically without touching it. and I get this screen: When I press reset, nothing happens. I've tried to switch computers and follow the same steps yet the outcome was the same.
Help would be greatly appreciated!
I am trying to configure 8 LPS nodes with the LPS configuration following the "getting started with the loco positioning system" however, when connecting the node via usb to my computer, nothing happens and the "apply" button is grayed out. I've installed Zadig and installed libusb-win32 (v1.2.6.0) to all of them, and I have updated each node with lps-node-firmware-2018.10.dfu
Once the the update it complete, the node switches from DFU mode to its regular mode automatically without touching it. and I get this screen: When I press reset, nothing happens. I've tried to switch computers and follow the same steps yet the outcome was the same.
Help would be greatly appreciated!