Can't apply a ID to the anchors

All discussions related to the Loco Positioning system
Post Reply
Sjuul
Beginner
Posts: 1
Joined: Fri May 10, 2019 11:59 am

Can't apply a ID to the anchors

Post by Sjuul »

Situation:
I have 8 anchors.
They are all have the libusb-win32 (v1.2.6.0) driver from the Zadig tool.
After that the lps-node-firmware-2018.10.dfu is correctly updated with the LPS configuration tool.

But after that I can't find a way to give them a appropriate ID.

(I using the tutorial from https://www.bitcraze.io/getting-started ... ng-system/)
arnaud
Bitcraze
Posts: 2538
Joined: Tue Feb 06, 2007 12:36 pm

Re: Can't apply a ID to the anchors

Post by arnaud »

Have you installed the Zadig driver for the anchor in firmware mode as well? If so, this is your problem.

You need to keep the default serial port driver when the nodes are running in firmware mode (ie. not DFU). If you have already set another driver from Zadig you can either uninstall and reconnect the node, or install the usb serial driver from zadig (it should be in the list of driver).
Post Reply