Low power mode in TWR
Posted: Wed Feb 27, 2019 4:56 pm
Hi,
I am a student at University of L’Aquila and I am new to Loco Positioning System.
I have read on Decawave documentiation about different low power mode I can use in order to set DW1000 anchors in TWR (i.e. “Low-Power Listening”, “Sniff Mode”, “Low Duty Cycle Sniff Mode”).
As far as I can work out, if I want to save power, I can choose one of these modes configuring my anchors and using the following configuration mode: PRF (16MHz), data rate (6.8 Mbps), Preamble length (128 symbols), releated to the Short Range TWR use-case.
I wonder know according to what I can select one low power mode or the other in order to minimize the power consumption and if it is possible to do that for TWR.
Thanks
I am a student at University of L’Aquila and I am new to Loco Positioning System.
I have read on Decawave documentiation about different low power mode I can use in order to set DW1000 anchors in TWR (i.e. “Low-Power Listening”, “Sniff Mode”, “Low Duty Cycle Sniff Mode”).
As far as I can work out, if I want to save power, I can choose one of these modes configuring my anchors and using the following configuration mode: PRF (16MHz), data rate (6.8 Mbps), Preamble length (128 symbols), releated to the Short Range TWR use-case.
I wonder know according to what I can select one low power mode or the other in order to minimize the power consumption and if it is possible to do that for TWR.
Thanks