Why I cannot configure node position data ?
Posted: Wed Feb 06, 2019 8:36 pm
Hi. I am new to Loco Positioning System and followed the tutorials to set up the drone and 8 DWM1000 anchors. I uploaded firmware-cf2-2019.02.1 to the CrazyFlie 2.0 and flashed all 8 anchors with the latest firmware (lps-node-firmware-2018.10.dfu).
I got stuck at the point where I have to configure the positions of the anchor nodes. The 8 anchors seem to be recognized fine by the PC client software (all anchors [0, 7] are green).
But in the view windows, I only get one blue dot and no green anchor dots. When I hit "Configure Positions" button and subsequently the "Get from anchors" button, nothing happens and the list stays empty.
A.) Some idea what I am doing wrong?
B.) What's the difference between cf2-2019.02.bin and cf2_nrf-2019.02.1.bin ?
Here's a screenshot:
I got stuck at the point where I have to configure the positions of the anchor nodes. The 8 anchors seem to be recognized fine by the PC client software (all anchors [0, 7] are green).
But in the view windows, I only get one blue dot and no green anchor dots. When I hit "Configure Positions" button and subsequently the "Get from anchors" button, nothing happens and the list stays empty.
A.) Some idea what I am doing wrong?
B.) What's the difference between cf2-2019.02.bin and cf2_nrf-2019.02.1.bin ?
Here's a screenshot: