Plastic case for the LPS Anchor
Posted: Wed Dec 19, 2018 3:31 pm
Hi,
We recently acquired a swarm bundle. We plan to 3D print a plastic case for every LPS anchor. Just wondering if there is any restriction on the case like for example not to block the LOS to the RF chip or the like. Best option is to encase the whole node but we are not sure if that will affect the signal needed by the drones. What is your recommendation on this matter?
Thanks,
Federico.-
We recently acquired a swarm bundle. We plan to 3D print a plastic case for every LPS anchor. Just wondering if there is any restriction on the case like for example not to block the LOS to the RF chip or the like. Best option is to encase the whole node but we are not sure if that will affect the signal needed by the drones. What is your recommendation on this matter?
Thanks,
Federico.-