[SOLVED] Can't get data from TDOA3 default log variables in GUI
Posted: Wed Dec 05, 2018 3:43 pm
Hello,
I was trying TDOA3 and positioning is working fine. However I tried to have a look to the LOG variables of TDOA3 but any of them is showing up in the graph (See picture below).
I am running last version of firmware.
Are these variables not implemented yet?
Where can I get information about TDOA3 variables and push it into ROS?
Thanks for you help.
Best regards
I was trying TDOA3 and positioning is working fine. However I tried to have a look to the LOG variables of TDOA3 but any of them is showing up in the graph (See picture below).
I am running last version of firmware.
Are these variables not implemented yet?
Where can I get information about TDOA3 variables and push it into ROS?
Thanks for you help.
Best regards