Page 1 of 1

don't read anchors position

Posted: Tue Dec 04, 2018 3:25 pm
by justinleeyang
hi, all:

try tdoa3 mode, I have open 8 anchors, and we want to get the anchors position with control table Anchor Position Configuration, but when click the Get From anchors, don't any reponse, why ?

Re: don't read anchors position

Posted: Wed Dec 05, 2018 7:44 am
by arnaud

A couple of questions to understand where the problem could be:
- On what system are you running the client and what is the version of the client are you running?
- Are the anchors visible as "GREEN" in the LPS tab?
- Is there a position already written in the anchors?

Re: don't read anchors position

Posted: Sun Dec 09, 2018 2:32 pm
by justinleeyang

1, crazyflie2.0 201810 release version
2, newest crazyflie client

when click button(Get From anchors), the anchor list was emptied.

Re: don't read anchors position

Posted: Mon Mar 11, 2019 1:45 am
by justinleeyang
I recheck the issue, find that when click the button, the crazyflie's dwm1000deck tx led don't blink, so read anchor's position infomation, don't get it from the anchor board.