[SOLVED!] LPS - Write to Anchor Issue in Client v2018.10
Posted: Tue Oct 30, 2018 2:48 pm
Hello everyone,
I wanted to configure my LOCO system. My system contains 6 anchors.
I have followed the instructions on the "Getting started with the Loco Positioning system" page.
As you can see, my all anchors are active and I can see them in my client as well. So I clicked the "Configure Position" in order to enter my anchor positions. However, 'Write to Anchor' button seems unresponsive. I have attached the screenshot:
Is there any solution regarding that? I am using Client version 2018.10, should I switch to previous version?
My other question, I don't see any anchor at the X/Y/Z map in client. Is it because I haven't configure the anchor positions or there is some other reason?
Thanks for help
Best Regards
Aybars
I wanted to configure my LOCO system. My system contains 6 anchors.
I have followed the instructions on the "Getting started with the Loco Positioning system" page.
As you can see, my all anchors are active and I can see them in my client as well. So I clicked the "Configure Position" in order to enter my anchor positions. However, 'Write to Anchor' button seems unresponsive. I have attached the screenshot:
Is there any solution regarding that? I am using Client version 2018.10, should I switch to previous version?
My other question, I don't see any anchor at the X/Y/Z map in client. Is it because I haven't configure the anchor positions or there is some other reason?
Thanks for help
Best Regards
Aybars