Page 1 of 1

Hover instability

Posted: Fri Dec 28, 2018 2:44 pm
by harriswang
Autonomous hovering is performed using the optitrack motion capture system and the ros operating system, but the aircraft flies to the Y-axis or Z-axis side after take-off, which is a specific problem. thank you

Re: Hover instability

Posted: Fri Jan 04, 2019 1:31 pm
by tobias
It could be that the crazyflie doesn't have any yaw information. It probably have to be started in the right direction for it to work properly.

Re: Hover instability

Posted: Thu Mar 07, 2019 1:25 am
by harriswang
Hello, we have used a lot of aircraft to carry out experiments, but one aircraft is able to complete the stable hovering mission. The only difference between this aircraft is that the marking points recognized by the motion capture system are placed on the aircraft differently, is it not? Does the position of the center of mass affect the experiment? Thank you

Re: Hover instability

Posted: Wed Mar 13, 2019 11:50 am
by arnaud
The center of mass will off course affect performance, but it should not make the Crazyflie unable to hold a position setpoint unless you have a big out of center weight.

From your problem description it seems like the tracking is not working properly for the affected Crazyflies or that the position estimate is not sent correctly to the affected Crazyflie.