Bitcraze Forums

Hi, I want to follow the example shown in the video on this page:
https://www.bitcraze.io/breakout-deck/

I have soldered the header pins to the Breakout deck to put it at the bottom of the crazyflie, then attached to a breadboard.

However, I find no further instructions of how to reproduce that example.

May I get help? I think I need a closer view to the setup / wires on the breadboard, and what was changed in the firmware code.

Thanks

I found there are instructions in the crazyflie-firmware repository, in the docs folder.

I think the information there could help me create something similar to the one in the video.