FLOWDECK transmission data to firmware crazyflie
Posted: Fri Apr 26, 2019 5:35 pm
Hi! I'm wondering if there's another method than debugging for verifying if the data that my flowdeck calculating is transmitter properly to my firmware on the crazyflie or not? in other words I mean
we know that flowdeck has two sensors and caluclating according to my movements while flying the crazyflie the coordination x y z and then flowdeck doing proper calculation and sending the height to my crazyflie's firmware .. any suggestions? thanks alot!
debugging is very hard and takes time .. I want just to verify the interface communication between my firmware and my flowdeck that's transmitted properly ..
we know that flowdeck has two sensors and caluclating according to my movements while flying the crazyflie the coordination x y z and then flowdeck doing proper calculation and sending the height to my crazyflie's firmware .. any suggestions? thanks alot!
debugging is very hard and takes time .. I want just to verify the interface communication between my firmware and my flowdeck that's transmitted properly ..