Bitcraze Forums

I've check and confirmed that my Crazyflie is facing the correct direction. I will start by taking off and landing, as per your suggestion. Also, I would like to ask regarding the Github which you and Kimberly linked met to. If I'm understanding this correctly, if I set lower-level commands and run ...

That did the trick! Thanks!

Hi, Basically, I would like to control the Crazyflie to move from (x,y,z) to (x1,y1,z1) within inside the LPS "box" while being able to access low level commands. I have taken a look at the examples/position_commander_demo.py and tested it on my Crazyflie. It seems to behave a little stran...

Thanks for the reply! I was able to fix it.

However, I'm encountering consistent "Too Many Packets Lost" when the Crazyflie is around an arm length away. I've tried changing the channels for it but it yields the same result on Windows.

Hi,

Thanks for your reply!

I had forgotten to mention that if all my questions take into account the boundary set by the LPS nodes.

Also, I think you had forgotten to link the issue which you wanted to mention when mixing two kinds of commanders.

Hi, I've been trying to flash the latest version of the Crazyradio firmware using Windows Powershell but I keep getting an error. I've attached the error in this thread. I was following the instructions from the https://www.bitcraze.io/docs/crazyradio ... ogramming/ and was able to launch into bootl...

Hi, I was looking through the Python library for Crazyflie but I'm confused about where I should start for my project because, from what I understand, there are alot of similar functions. I would just like to see where the following functions are: 1. The turning velocity 2. Moving from Point A to Po...

Hey Kimberly, Sorry, I had misunderstood the instructions regarding the installation of the expansion decks. It seems to be working fine right now! One quick question, I am currently experiencing consistent "Too Much Packet Lost" error. Is changing the radio channel the only way to go abou...

Hello! Once again, thanks for your reply. 1. I'm sure it mounted properly (though I don't have any extension pins currently with me). Are the decks on the Deck supposed to light up as well when the Crazyflie is turned on? 2. The RX LED is constantly blinking. 3. My LPS Nodes are powered via USB. Che...

Hey Kimberly,

Thanks for your reply. It seems building from that link has stopped the random freezing of the program however, I still can't seem to see the LPS in the client. I have tried using two different nodes.

Cheers,
Youngbin